MSI 6741 DRIVER

Please turn off the power and unplug the power cord before installing the CPU. Locate the CPU and its retention mechanism on the motherboard. Look for the gold arrow. Press the two levers down to fasten Press down the fan until its four clips get wedged in the holes of the retention mechanism. Press the CPU down firmly into the socket and close the lever.

Uploader: Vugul
Date Added: 4 September 2012
File Size: 59.91 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 90723
Price: Free* [*Free Regsitration Required]

Mount the fan on top of the heatsink.

You must configure second hard drive to Slave mode by setting the jumper accordingly. Make sure to raise the lever up to a 90degree angle. You can attach a serial mouse or other serial devices directly to smi connector.

Press the CPU down firmly into the socket and close the lever. The plastic clip at each side of the DIMM slot will automatically close. The connector location and pin assignments are as follows: Line In is used for mai CD player, Tape player, or other audio devices.

Locate the CPU and its retention mechanism on the motherboard. The CPU can only fit in the correct orientation.

Support For K8MM-ILSR | Motherboard – The world leader in motherboard design | MSI Global

The third PCI slot supports 2 master devices. Overheating Overheating will seriously damage the CPU and system, always make sure the cooling fan can work properly to protect the CPU from overheating.

  CONNECTION TERMINATED EACFILT DRIVER DOWNLOAD

You can plug the USB device directly into the connector. Smi module will only fit in the right orientation. The gold arrow should point towards the lever pivot.

MSI Ms-6741 K8mm-ilsr Ver 1 Socket 754 Motherboard With BP

If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. Connect the fan power cable from the mounted fan to the 3-pin fan power connector on the board.

When adding or removing expansion cards, make sure that you unplug the power supply 67441. Also, it provides the instructions on connecting the peripheral devices, such as the mouse, keyboard, etc.

MSI K8MM-ILSR – motherboard – micro ATX – Socket 754 – K8M800 Series

Position the heatsink onto the retention mechanism. You can barely see the golden finger if the module is properly inserted in the socket. Then push it in until the golden finger on the memory module is deeply mssi in the socket. Please note that any violation of the correct installation procedures may cause permanent damages to your mainboard.

MSI MS Specifications |

Meanwhile, read the documentation for the expansion card to make any necessary hardware or software settings for the expansion card, such as jumpers, switches or BIOS configuration. Please turn off the power and unplug the power cord before installing the CPU.

  GA-MA78GM-S2H AHCI DRIVER

It introduces a 66MHz, bit channel for the graphics controller to directly access main memory. Press the two levers down to fasten Press down the fan until its four clips get wedged in the holes of the retention mechanism. Look for the gold arrow.

J9 Optional You can connect a joystick or game pad to this connector. When you are installing the CPU, make sure the CPU has a heat sink and a cooling fan attached on the top to prevent overheating. Follow the instructions below to clear the data: As the CPU is likely to move while the lever is being closed, always close the lever with your fingers pressing tightly on top of the CPU to make sure the CPU 671 properly and completely embedded into the socket.

Floppy Disk Drive Connector: Memory modules can be installed in any combination as follows: If the CPU is correctly installed, the pins should be completely embedded into the socket and can not be seen.

Start the discussion

Leave a Reply

Your email address will not be published. Required fields are marked *