GTCO ROLL-UP II DRIVER DOWNLOAD

Did you connect the digitizer to your computer’s modem using a telephone cord? What issues are you having with the site? Most boxes have been opened for inspection and photos. This option is available only in Summagraphics formats. Cha racter For mat and Baud Rate.

Uploader: Jurn
Date Added: 1 January 2004
File Size: 60.94 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 8705
Price: Free* [*Free Regsitration Required]

This warranty gives you specific legal rights, and you may have other rights, which vary from state to state, or province to province. Click ‘Point 2’ – beeping will stop. Care and Handlin g. You are gtci a Tabletworks version designed for the wrong version Windows. Make sure that Tabcon is NOT checked. Connect the interface cable to the appropriate jack on the connector panel. S 0 1 2 3 4 5 6 7 8 9 P It has dip switches for soft settings under the small removable template.

How To: Configure the GTCO Roll-Up II digitizer

Read Tablet Diodes Code: Same as 5 above. This will start TabletWorks.

  M17X R3 CAMERA DRIVER DOWNLOAD

For example, the buttons eoll-up a 4-button cursor could represent four line widths or four colors. Each character has one or two stop bits, which tell the receiving device that a character is complete.

GTCO Rollup II Digitizer $2755

Page 6 Roll-Up II 6 5. The digitizer can draw power from both 2. Electronic items often emit radio waves. Roll-Up II 9 Table 1: Also shop in Also shop in.

Roll-Up II 34 buffer full; a modem to indicate carrier detect; and a time-shared computer that services multiple users roll-u a time-available basis. Go back to Solution 1 and repeat it. Cha racter For mat and Baud Rate. Roll-Up II 41 The size is encoded as four digits: Open TabletWorks by double clicking its icon in the System Tray.

What issues are you having with the site? If your system still does not work.

Read through the list below to find the solution to your situation. The connection of the cable from the digitizer to the computer is loose or unplugged. If you have a serial digitizer, did you set the SuperSet code to configure the digitizer for TabletWorks?

  IBOOST MOUSE DRIVER

Graphite is an electrical conductor and interferes with the signal from the stylus. Click the [Ok] button to exit TabletWorks. Proceed to “Solution 3”.

GTCO Roll-Up II – Users Guide User Manual | 70 pages

To restart the TabletWorks driver: This unit has the 36″ x 48″ active area. If you don’t, then plug the power supply into the digitizer. Roll-Up II Interfa cing. The solution is to replace the florescent lamp with an incandescent one. The Rll-up II is now ready to accept commands.

Start the discussion

Leave a Reply

Your email address will not be published. Required fields are marked *